2005 Chevy Colorado Driver Window And Door Locks Not Working

For that reason lets focus there for the moment.

2005 chevy colorado driver window and door locks not working.

I was having problems with my drivers side window and locks not working on my 2005 chevy colorado. I disconnected the negative battery terminal for cleaning and when i reconnected it i found that my driver s side power window but not the passenger side and both power door locks did not work. I got the driver window and door locks not working again. The part i love is how the truck always dings and throws battery is codes when its cold out and how the truck goes from 1 2 a tank to empty when you tap the brakes of shift into neutral.

I was getting frustrated since i really do not have the money to replace parts. That s to enable the bcm to trigger locking and unlocking. I ve run out of things to try other than going to a chev shop to get my driver s window and all door locks to work. I checked all fuses even 68 relay but still could not find problem i drove 18 miles in 30 degree weather at nite got home and was very confused with this truck.

For the locks the bcm does have two signal outputs to the window door lock module. I found this forum while searching for a solution to a recent problem. For the windows the bcm is not involved at all. On my 2005 chevy colorado my battery died while my truck sat for two weeks.

I have checked the fuses u read more. Can every admit that chevy is really on the ball these days. The driver side window was stuck down and all door locks would not work all the other windows went up and down as they should but still no drivers window or door locks. I tried this 10 step process and it worked so thank you so much for this.

After i charged it up the driver s side front door power window and door locks are not working. I found other solutions that were said to work and did not work. My 2005 z71 ls colorado was missing 20 amp fuse for pwr lcks put one in and locks started working and driver window would go down but not up took the driver door control apart and used a paper clip to short the connections on the circuit board found that the white pegs that make the connection from the buttons to the circuit board were out of place i needed to keep shorting the board and.